|
Control your Bi-mode Z06/ZR1 or NPP exhaust with your FOOT
Installs in minutes, simply
remove the OEM dead pedal (very easy, 2 nuts) and install this one. The special
flat wire harness simply passes from the driver side to the passenger side and you then simply plug in the adapter into the
fuse block. No ground wire to install.
Zero drain, starts in the last
setting you left it. No fob, no wireless, no visor. The heavy duty switch is in simple reach, press loud, press quite, how simple. You can even switch it prior to starting the car.
I can offer this in a ready
to install version like this, complete with new OEM dead pedal. All the best
parts and a 3-5 min install.
Or you can use your dead pedal
and you will just need to drill a 1/2" hole for the switch and install the switch and you have the same item as above. I provide a heavy duty switch, stress relief block and zip tie, special flat
shielded cable, Fuse taps and fuses and special exhaust fuse bypass spade. 10
min install.
Shown installed in the dead pedal
OLD School Kit (use your dead pedal) - $49.99
OLD School Kit Pre-Installed w/ New Dead Pedal - $85.99
OLD School Kit Pre-Installed w/ Elite Pedal Set - $141.99 (use your OEM dead pedal)
OLD School Kit Pre-Installed w/ Elite Pedal Set in new OEM dead pedal $177.99
|
