C5 / C6 Speaker Mounts

MAIN MENU
Mag Charger
Carbon Fiber Visor Overlays
Mild2Wild / NPP Exhaust Control Products
Customer Photo Gallery / Videos
Our Policies
Instructions
Contact Us
Customer Comments
Stainless Polishing Kit
C5 / C6 Speaker Mounts

 

CNC Machined C5 / C6 Door Speaker Mounting Plates

 

So you're looking to upgrade the speakers in your C5 / C6 or Z06 and you need a way to mount an aftermarket driver in the stock openings. You could use plywood and make the shape yourself, but if you're really into audio then you'll be concerned that wood will absorb moisture and may not be stiff enough to get the most out of the drivers you just dumped a TON of money on. We have exactly the what you need, an exact fit, CNC machined mounting plate made of 5mm (approx 0.205") thick high pressure canvas phenolic laminate. This premium material is extremely dense which makes it very moisture resistant and also very stiff, ready to handle hardest hitting drivers. 

 

C5 = The plates (2) are setup for a 6.5" 2-way component set with a 143mm (5.625") hole for the midbass driver and a 46mm (1.8") hole for mounting a tweeter. For those that mount the tweeter elsewhere, the space above the midbass can be used for the crossover instead. Holes are pre-dilled to match the mounting pattern of the door, so all you have to do is drill the pattern for whatever speakers you're
installing(pilot drilling STRONGLY recommended!).

C6 = The set consists of 4 pieces, 2 each for the 10" sub opening in the door and 2 for the 3.5" midrange mount in the door panel. The 10" has a 143mm (5.625") hole that is offset 1/2" down and over, to maximize the exposure of a driver to the door panel grille. The 143mm (5.625") hole will accommodate almost any 6.5" driver, but check the driver's specs to make sure the speaker will pass through the opening and rest on its frame. The 3.5" plate has a 46mm (1.811") hole to accommodate many aftermarket tweeter pods. All you need to do is drill holes to mount your specific speaker. The material will hold screws better than wood so you can use self-tapping screws for mounting or drill through for the a clip or nut on the back side.

C5 Set

c5plates1.jpg

c5plates2.jpg

C6 Set

c6speaker1.jpg
c6stereo1a.jpg

c6stereo2a.jpg

Shipping on these is with in the continental 48 states only.  If outside that area, please email for the rate.

Standard 6.5" 2-way Configuration: $50
C6 -  IN STOCK
C5 - IN STOCK
 
 

Select C5/C6

Instructions

  

Solution Graphics

Sales Tax Will Be Added To All NY Shipping Addresses
 
All orders ship USPS priority mail, we ship within 48 hrs of your order for instock parts.
 
ALL information found on this site is under the Copyright © 2005-2017 LEEA Customs Inc. All rights reserved.
 
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.
Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for www.nakidparts.com content, comments, or advertising. www.nakidparts.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended.
 
All installation and use of the products purchased from Nakidparts.com / LEEA Customs Inc. are done at the owners own risk.  Nakidparts can not be held responsible for any damage or injury caused by the installation or use of the products purchased here (sorry, the lawyers made me say it)
 
 The user agrees to these terms by the act of using / purchasing these products